Skip to main content

HBase is able to connect to ZooKeeper but the connection closes immediately

I got following error when i tried to connect hbase from hadoop nodes. Zookeeper servers runs normally but hadoop nodes can not connect remote zookeeper cluster.

ERROR: org.apache.hadoop.hbase.ZooKeeperConnectionException: HBase is able to connect to ZooKeeper but the connection closes immediately. This could be a sign that the server has too many connections (30 is the default). Consider inspecting your ZK server logs for that error and then make sure you are reusing HBaseConfiguration as often as you can. See HTable's javadoc for more information.

Then i fixed problem copying hbase-site.xml to hadoop/conf directory.


Popular posts from this blog

Creating Multiple VLANs over Bonding Interfaces with Proper Routing on a Centos Linux Host

In this post, I am going to explain configuring multiple VLANs on a bond interface. First and foremost, I would like to describe the environment and give details of the infrastructure. The server has 4 Ethernet links to a layer 3 switch with names: enp3s0f0, enp3s0f1, enp4s0f0, enp4s0f1 There are two bond interfaces both configured as active-backup bond0, bond1 enp4s0f0 and enp4s0f1 interfaces are bonded as bond0. Bond0 is for making ssh connections and management only so corresponding switch ports are not configured in trunk mode. enp3s0f0 and enp3s0f1 interfaces are bonded as bond1. Bond1 is for data and corresponding switch ports are configured in trunk mode. Bond0 is the default gateway for the server and has IP address Bond1 has three subinterfaces with VLAN 4, 36, 41. IP addresses are,, respectively. Proper communication with other servers on the network we should use routing tables. There are three

Sending Jboss Server Logs to Logstash Using Filebeat with Multiline Support

In addition to sending system logs to logstash, it is possible to add a prospector section to the filebeat.yml for jboss server logs. Sometimes jboss server.log has single events made up from several lines of messages. In such cases Filebeat should be configured for a multiline prospector. Filebeat takes lines do not start with a date pattern (look at pattern in the multiline section "^[[:digit:]]{4}-[[:digit:]]{2}-[[:digit:]]{2}" and negate section is set to true ) and combines them with the previous line that starts with a date pattern. server.log file excerpt where DatePattern: yyyy-MM-dd-HH and ConversionPattern: %d %-5p [%c] %m%n Logstash filter: